Husqvarna T 4000 Petrol Operator's Manual page 11

1. Clean the prefilter if the manometer is above the
filter cleaning level (B). Refer to
on page 17 .
2. Replace the HEPA filter if the suction continues to
be not sufficient. Refer to
page 17 .
To discard a full Longopac bag and prepare a
new Longopac bag
WARNING:
caution, a full Longopac bag can be heavy.
Make sure that the cable ties are closed
correctly before you lift the Longopac bag.
1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
2. Shake down the dust in the used Longopac bag.
2065 - 001 - 12.06.2023
B
A
To clean the prefilter
To replace the prefilter on
Lift the Longopac bag with
A
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties.
C
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac dust bag on page 18 .
5. Obey local regulations for disposal of the full
Longopac bag.
To attach the hose
1. Remove the inlet plug.
2. Lift the lock pin (A) and put the hose adapter (B) into
the inlet.
3. Release the lock pin and make sure that it locks the
inlet adapter.
To install a
A
B
11