Page 1
SWPP14 12VCar/24V Truck Heavy Duty Power Station and Emergency Jumpstarter 12V Car Voltage Peak output 2500 Amps 24V Truck 1200 Amps IMPORTANT WARNING: This product is only supplied with a minimal amount of charge at manufacture, therefore for this product to operate correctly, it has to be fully charged for a period of 48 hours IMMEDIATELY after purchase.
Page 2
Intention For Use Thank you for purchasing this Heavyweight Portable Power Station & Emergency Jumpstart Pack from Streetwize. This product is intended for performing emergency jumpstarts on vehicles with both 12V batteries and 24V batteries. It is also suitable for emergency jumpstart 12V/24V in boats.
Page 3
Warning Symbols Explained Symbol Explanation Danger of Explosion General hazard Danger of corrosive substances Danger of electric shock Eye protection must be worn Protective clothing must be worn Please dispose of this product in thecorrect manner in line with your local authority M17 1RY...
Page 4
Health & Safety Guidelines IMPORTANT: Only use this product if you have sufficient knowledge or experience of using this type of product. WARNING: To minimise the risk of personal injury and from damaging to the equipment, we advise that you comply with all the essential health & safety guidelines and precautions as outlined below: •...
Page 5
Usage Instructions Charging The Power Station The power station will be partially charged on purchase. That said, for optimum performance, we advise that you fully charge the power station for 48 hours before first use. IMPORTANT: We recommend keeping the battery fully charged at all times. A low charge level could shorten the life of the battery.
Page 6
Recharging The Battery Using 12V DC Power Supply 1. First, ensure the power station switch is set to OFF (Figure C). 2. Then, connect the supplied 12V DC power cable (Fig B-10) to the power station and then plug into your vehicle’s 12V vehicle socket.
Page 7
Performing a Jumpstart 1. To perform an emergency jumpstart, please follow the instructions below: 2. Also, make sure that your vehicle/boat is fully switched. 3. Connect the red clamp (+) of the power station to the positive battery terminal. 4. Then, connect the black clamp (-) of the power station to your vehicle’s body work. Important: Never connect the black clamp to your battery’s negative terminal.
Need help?
Do you have a question about the SWPP14 and is the answer not in the manual?
Questions and answers