Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock.
Do not use electrical adapters with the product.
Extension cables
•
Use only approved extension cables with sufficient
length.
•
The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
•
Use grounded extension cables.
•
When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
•
Keep the connection to the extension cable dry and
off the ground.
•
Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
•
Make sure that the extension cable is in good
condition and not damaged.
•
Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
•
Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
•
Do not use a product with safety devices that are
damaged or do not operate correctly.
•
Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
•
Do not make modifications to safety devices.
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
To do a check of the start/stop and function selection
switch
1. Set the start/stop and function selection switch to
"0".
1804 - 003 - 28.08.2023
Read the warning
2. Connect the product to the power supply.
3. Set the start/stop and function selection switch to
"1".
4. Push the forward drive lever. The drive motor starts.
5. Set the start/stop and function selection switch to
"2". The drive motor is on and the vibration motor
starts.
6. Set the start/stop and function selection switch to
"0".
7. Make sure that the drive motor and the vibration
motor stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
•
Be careful when you replace the blade, it is very
sharp. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
•
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
•
If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
•
Clean the product to remove dangerous material
before you do the maintenance.
•
Remove the blade before you do the maintenance.
•
Before you do the maintenance, stop the motor and
disconnect the power plug.
•
Do the maintenance of the product on stable level
ground.
•
Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
•
Replace damaged, worn or broken parts.
•
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
•
Let an approved service agent do servicing on the
product regularly.
Read the warning
9