Ruijie RG-SAP825-SP Hardware Installation And Reference Manual page 46

Hardware Installation Guide
high-temperature cables should be used. If heat sources cannot be avoided, high-
temperature cables should be used.
When screw threads are used to fasten cable terminals, the anchor or screw must
○
be tightly fastened.
Figure 7-7 Cable Fastening
Hard power cords should be fastened in the terminal connection area to prevent
○
stress on terminal connection and cable.
Do not use self-tapping screws to fasten terminals.
○
Power cords of the same type and in the same cabling direction should be bundled
○
up into cable bunches, with cables in cable bunches clean and straight.
Bind the cords with buckles according to the following table.
○
Table 7-3 Cable Bunch
Cable Bundle Diameter (mm)
10 mm (0.39 in.)
10 mm to 30 mm (0.39 in. to 1.18
in.)
30 mm (1.18 in.)
① Flat washer
② Nut
Distance between Every Binding Point
80 mm to 150 mm (3.15 in. to 5.91 in.)
150 mm to 200 mm (5.91 in. to 7.87 in.)
200 mm to 300 mm (7.87 in. to 11.81 in.)
42
③ Spring washer
④ Flat washer
Appendix