Barista Mode; Latte Mode; Party Mode; Water Hardness - Miele CVA 7840 Operating And Installation Instructions

Barista mode

This performance mode has been
optimised for unadulterated coffee
enjoyment. Users can enjoy coffee-
based drinks without any delay as the
coffee machine remains heated to the
brewing temperature. This mode
consumes more energy than Eco mode.

Latte mode

This performance mode has been
optimised for preparing milk. Milk-
based drinks can be prepared within a
much shorter space of time. This mode
consumes more energy than Eco mode
and Barista mode.

Party mode

This performance mode has been
configured for the occasional intensive
use of the coffee machine, e.g. for
family get-togethers.
Before switching off the coffee
machine, empty the drip tray and fill
the water container so that any
pending maintenance programmes
are able to run.
Clean the coffee machine thoroughly
after intensive use, particularly the
milk pipework. It may be necessary
to descale the coffee machine
manually and degrease the brew
unit.
Please note the following information
about Party mode:
- The general pipework is rinsed much
less frequently or not at all. The milk
pipework is not rinsed until
around 1 hour after milk was last
dispensed.
- Cleaning status messages or
cleaning prompts are suppressed
and delayed until the machine is next
switched on.
- The and
Off at
are deactivated. The coffee machine
switches off 6 hours after the last
sensor was pressed.
- The cup light remains permanently
switched on at the maximum
brightness level for as long as the
coffee machine stays switched on.

Water hardness

Programme the coffee machine to the
water hardness level of your area so
that it functions correctly and does not
get damaged.
Contact your local water supplier to find
out your local water hardness range if
necessary.
If you are using bottled drinking water,
e.g. mineral water, select settings
according to the calcium content. The
calcium content is specified on the label
of the bottle in mg/l Ca
2+
(mg Ca /l).
Do not use carbonated water.
The hardness level is set to 21 °dH by
default.
Settings
timers
Switch off after
2+
or ppm
55