Replacing With A Used Arc Board - Oki LP-1040 Maintenance Manual

1.7.2

Replacing with a Used ARC Board

Follow the procedure below when replacing the ARC board with board already used.
(1) Turn the Printer off.
(2) Remove the ARC board from the Printer.
(3) Replace the EEPROM on the new ARC board with the EEPROM from the old ARC board.
See p.9-55 for the ARC board EEPROM replacement procedure.
See p.9-63 for the ASC board EEPROM replacement procedure.
(4) Install the new (used) ARC board to the Printer.
(5) Turn the Printer on.
The message The product key is not correct, or the ARC board's EEPROM has not
been replaced may be displayed.
In such as case, enter the product key following the procedure in 4.6 The product key is
not correct, or the ARC board's EEPROM has not been replaced error.
(6) The Printer starts normally.
(7) If the message The printer will operate for 720 hour(s) only is displayed in yellow on the
Ready screen on the operation panel, enter the product key following the procedure in 4.9
The printer will operate for 720 hour(s) only is displayed on the Ready screen.
(8) Check that the Printer has started properly following the instruction in 1.8 Checks After
Firmware Upgrade and Board Replacement.
Chapter 1 Maintenance Work Process Overview
1-21