Safety Precautions Product Overview Operation Instruction 03-10 Cleaning and Maintenance Troubleshooting 12-14 Important Safety Tips Specifications Product Warranty Information *BEFORE FIRST USE* To prevent any internal damage, it is very important to keep refrigeration units ( like this one) upright throughout their journey.
SAFETY PRECAUTIONS Thank you very much for choosing Aiusevo, wish our dehumidifiers could help to guarantee the health of your whole family To operate the dehumidifier better and achieve the best effect, please read the manual carefully before first use and keep it for future reference.
There is Clothes-Dryer Mode, Dehumidify Mode, Continuous Dehumidify Mode. After the machine is turned on, press the [Mode] button to switch the working modes. Each time pressing the button, the machine will cycle through the Clothes-Dryer mode, the Dehumidifying mode, and the Continuous Dehumidifying mode. Notices: In the Clothes-Dryer Mode: Both the humidity and fan speed are not settable.
Page 6
LOOK When the machine is turned on, press and hold the "LOCK" button for 2 seconds, the control panel will be locked together with the other function buttons. To unlock the control panel, press and hold the "LOCK" button again for 2 seconds. The speed button is used to control the fan's speed, it can be switched to the high -speed mode or low-speed mode.
Page 7
Auto Defrost Function When the machine is running at a lower temperature, the system will automatically determine whether there is a presence of frost. If the machine determines there is a presence of frost, it will start to defrost automatically. Defrost Action The fan will run at the high-speed mode while the compressor will stop working.
Page 8
.Instruction for Clothes-Dryer Mode The dehumidifier can be used for drying clothes in rainy weather. Step 1. Hang the washed clothes in a small space such as a cloakroom, bathroom, or storage room. Notice: Keep the unit away from the water drip from the washed clothes. Step 2.
Page 9
4. Error&Protection Code Fault phenomenon The humidity always shows "25%RH" (there is a big difference from the actual humidity) The humidity always shows "99%RH" (there is a big difference from the actual humidity) Analysis of causes The humidity sensor failure? 1.
Page 10
5. Empty the Water Tank There are two ways to remove collected water. Use the water tank When the water tank is already full, the Full Tank Alert indicator light will turn on, the dehumidifier will automatically shut down until the tank has been emptied and placed back in the unit.
Page 11
Notices: Do not remove the float from the water tank. If the float in the water tank is remov ed, the sensor may not be able to determine the water level stored in the tank properly which may lead to a water overflow leak from the water tank. If the water tank is dirty, just use cold water or warm water to clean it.
Page 12
6. Continuous Drainage Remove the power supply, take out the water tank, open the drain cover and plug, insert the water pipe into the continuous drain port and push it back into the water tank. Connect the power supply to start the operation. The water outlet of the water pipe should be lower than the continuous drainage port by more than 3.9 inches, and the water pipe cannot be bent.
Turn the dehumidifier off and remove the plug from the power source before cleaning Please use only a soft and a bit wet textile or cloth to clean it. Pull out the filter. Clean the filter: use a vacuum cleaner to gently remove the dust from the surface of the filter.
Check the information below for troubleshooting steps that will save your time to resolve issues that may happen with the unit. This list includes the most common issues. Listed below are not the result of a defective unit, crafts, or materials in the unit.
Page 15
The dehumidifier does not dry the air as it should...
Page 16
The water tank has not been Re-install the water tank properly. installed properly. Set the humidity to 30% RH,the dehumidifier can still continue Humidity always shows "25%RH" to work, and can be used normally. Humiditysensorfailure? (there is a big difference from Repair and replace the humidity the actual humidity)...
IMPORTANT SAFETY TIPS When using, please do not When using, please keep put the machine on soft and the machine away from the uneven ground, avoid heating furnace, electric vibration and movement. kettle, and other heat sources. When cleaning the humidifier fuselage, please use a wet cloth or textile to wipe the unit's surface gently, do not splash...
PRODUCT WARRANTY INFORMATION We offer a one-year warranty. If you have any questions or product issues during this period, please contact our official service team: service@Aiusevo.co We will reply and answer your questions within 24 hours. Please don’t worry we will always stand behind our products and provide you with the best service.
Need help?
Do you have a question about the AS-320 and is the answer not in the manual?
Questions and answers