Specifications - Sony HT-DDWG700 Operating Instructions Manual

Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels driven, from
120 - 20,000 Hz; rated 85 watts per channel
minimum RMS power, with no more than 1%
total harmonic distortion from 250 milliwatts
to rated output.
Amplifier section
P(y_'er Output l)
Stereo mode (rated) (6 ohms 1 kHz, THD lff_)
85W+85W
Surround mode 2) (reli_rence)
(6 ohms 1 kHz. THD 10(/_)
RMS output
FRONT: 133 W
per channel
CENTER: 133 W
SURROUND: 133 W
per channel
Surround mode 2) (reli_rence)
(6 ohms 100 Hz, THD 10%)
SUB WOOFER: 135 W
l)Measnred nnder the following conditions:
Area code Power requirements
U, CA 120 V AC, 60 Hz
2)Reference power output for front, center, snrronnd
speakers and sub woofer. Depending on the sound
field settings and the sonrce, there may be no
sound ontput.
Inputs
Analog
Digital (Coaxial)
Sensitivity: 800 mV/
50 kohms
Impedance: 75 ohms
Tone
Gain levels _+6dB. I dB step
Reproduction frequency range:
28 20,000 Hz
FM tuner section
Tuning range 87.5 - 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms, unbalanced
Intermediate fi'equency
10.7 MHz
AM tuner section
Tuning range
With lIt-kHz tuning scale:
530- 1,710 kHz 3)
With 9=kHz tuning scale:
531 - 1,711) kHz 31
Antenna Loop antenna
Intermediate fi'equency
450 kHz
3)You can change the AM tuning scale to 9 kHz or
10 kHz. Al-ler tuning in any AM station, turn off
the receiver. While holding down MOVIE, press
I/(_. All preset stations will be erased when you
change the tuning scale. To reset tile scale to 10
kHz (or 9 kHz), repeat tile procedure.
General
Power requirements
Area code Power requirements
U, CA 120 V AC, 60 Hz
Power output (DIGITAL MEDIA PORT)
DC OUT: 5 V, 0.7 A MAX
Power consnmption
Area code Power consumption
U 220 W
CA 290 VA
Power consumption (during standby mode)
0.3 W
54us