Husqvarna BLi100 Workshop Manual page 13

3. Remove the 4 screws.
4. Put the screws at a safe distance from the battery.
5. Push and hold the clips and remove the top cover
and the clips.
WARNING: The springs in the top cover can
cause a short circuit if the springs fall from
the top cover.
6. Push out the battery connector from the slot.
1856 - 001 - 14.04.2022
7. Remove the battery pack. Hold the battery pack at
the ends of the circuit board to prevent short circuit.
WARNING: Do not touch the circuits on the
circuit board.
8. Replace all damaged parts.
9. Install the new casing in the opposite sequence.
Note: Push the top cover in the direction of the
casing when you install the screws.
Repair instructions - 13