Table of Contents
Advertisement
4.2. Interface Configuration
The Capture > Interface Configuration page contains information and settings for the capture interface.
To change the interface settings, several tabs are available.
4.2.1. Port Control
If IOTA is intended to be used in-line, the appropriate configuration must be set. In-Line mode is the default
mode (Inline Mode checkbox ticked). IOTA can be set to SPAN mode by unticking the Inline Mode
checkbox.
IOTA 1G / 1G+
Port speed and behavior can be set on this screen.
IOTA 10G / 10G+
Loopback mode can be enabled when SPAN mode is enabled (Inline Mode checkbox unticked) by ticking
the Loopback checkbox.
The firmware can be set to either 1G or 10G mode via the Firmware Mode drop-down menu.
29
Advertisement
Table of Contents
Need help?
Do you have a question about the IOTA 1G and is the answer not in the manual?
Questions and answers