Table of Contents
Advertisement
4. Remote Detergent Housing (Optional)
The remote detergent housing is typically located under the trough to
facilitate refilling and priming of detergent. To prime pump depress
prime pump switch until fluid is seen flowing through pump. If pump
does not prime due to air in line, remove upper discharge detergent line
and prime pump. Set stroke of pump with adjustment knob located on
pump. Use a detergent with a disinfecting agent. (WEAR PROTECTIVE
EYE GEAR). [See fig. 5.7]
5. Drive Housing
The standard housing is equipped with side panels that are removable
(with tools) for access to sprockets, chain, motor and gear box. The
conveyor must be turned off before the panels are removed.
Double hinged, double pan doors are available as an option.
An optional interlock switch will prevent the conveyor from running
when a panel or door is opened. [See fig. 5.8].
6. Beam Switch
The beam switch is an optional feature designed to stop the conveyor as
items reach a certain location or are being stacked up at the end of the
conveyor. To service this unit, turn off conveyor and access the switch
by removing the screws (or nuts) and switch housing. Reverse steps to
re-assemble. [See Fig. 5.9 - 5.10]
7
OM-MOTORIZED CONVEYOR SYSTEM
Fig. 5.7
Fig. 5.8
Fig. 5.9
D. Routine Servicing
1. Gear Box
• The gearbox is lubricated for life, overhaul is required to change oil.
2. Belt
• Visually inspect every month for wear, chips, scratches, cracks or
signs of misalignment.
3. Intermediate Drive Chain
• Lubricate the Intermediate Drive Chain [which runs from the
gearbox to the belt drive sprocket] after one [1] month of operation.
• Lubricate after four [4] months of operation thereafter.
• Recommended Lubricant:
Roller Chain Lubricant
McMaster-Carr No. 6159 K11 or equivalent.
Fig. 5.10
Advertisement
Table of Contents
