Kenwood KM330 Service Manual page 3

Spares - KM330 / KM630 series - Disassembly & re-assembly instructions
Use a mincer.
Attach the mincer and position a
screwdriver between the cutter blades
and close to the scroll to stop it
rotating. Please note, it is advisable to
use the coarse screen as this allows
room for a larger
screwdriver. Undo the gearbox pulley
by hand anti-clockwise.
The pulley is a tight fit on the pinion
shaft. Use two screwdrivers to prise it
off.
Re-assemble using the stall plug /
mincer, turning pulley clockwise to
tighten.
http://www.kenwoodservice.co.uk/product-files-kar/guide-KM330.htm
diameter
Page 3 of 15
30/04/2009