Advertisement
CONTENTS
Precaution for Use
Names of the Parts
Adjusting the Brightness
Setting the Time & Checking the Seconds
Automatic Power ON/OFF Setting
Checking the Automatic Power ON/OFF Set Times
Temporary Power OFF During Automatic Power ON
When Not Using the Automatic Power ON/OFF
Functions
When Supplying Power Continuously
Example for Setting the Time
Example of Automatic Power ON Setting
Trouble-Shooting Guide
Cabinet & Chassis Exploded View & Parts List
puP2725 Block Diagram
Schematic Diagram
Precautions
for use
|
Before use, check whether the power line AC selector
switch on the rear panel of the unit is set properly.
If the setting does not coincide with the values in your
area, this may result in a breakdown or in incorrect time
display. Therefore, make sure that the selector switch is
set properly.
Caution:
When
changing the position of the AC selector, do not
remove the two screws at the same time.
Do not place the unit immediately above or beside a radio
or receiver, etc. with a built-in ferrite bar antenna.
This may generate noise.
ET 3510
Printed Circuit Board (Bottom View) & Parts List
3
re)
Do
not connect
the unit to a radio, etc. with a power
consumption of less than 2W or 3W.
The
switch
which
is coupled
to the timer may not be
turned off.
Do not connect the unit to a tape deck or tape recorder
which
is not provided with a stand-by
mechanism.
This
may
result
in a breakdown
of the tape deck
or tape
recorder.
This unit should be operated only at the 50 Hz area.
Advertisement
