Table of Contents
Advertisement
Decision of the design start position
To execute
(2)
When the tracing is impossible due to the design size exceeding the embroidery space, follow the procedure
below after checking the size of the design.
(a) The frame will move again after temporary stop.
(b) Code No.225 will be displayed.
Press E key.
(c) Move the frame to the design start position.
(d) Perform tracing again.
To interrupt trace, follow the procedure below.
(a) Suspend the operation by the bar switch or the stop switch.
Code No.1C1 will be displayed.
Do not turn OFF while code No. 1C1 is displayed.
(b) Press E key.
(c) After that, follow the message described below.
OK to continue Tracing?
84
Low
"YES">>SET
"NO">>E
To continue → SET key
To suspend →E key
Chapter 4
RR12R
Advertisement
Table of Contents
