Table of Contents
Advertisement
3-band Parametric Equalizer
Adjustment
1. Recall the equalizer curve to be
adjusted.
Recall a factory curve or user's curve
(equalizer curve created and stored in
this unit by yourself (Refer to following
section)).
(Refer to "Recalling a Factory Curve" on
page 29 and "Recalling a User's Curve"
on next page.)
(The selected band blinks.)
30
4. Press (<4) or (®) side of buttons [5] to
select the frequency to be adjusted.
Band 1 Band 2
Band 3
Band 1: 20 Hz — 3.15 kHz
Band 2: 80 Hz — 8 kHz
Band 3: 200 Hz — 20 kHz
It is not possible to set 2 adjacent bands
at an interval of less than 4/3 octave.
. Press (A) or (W) side of buttons [6] to
adjust the level.
(Numeric display [17] shows "-10 dB —
10 dB".)
=
tomcat
yee See
=
LLSEAT:
18
. Adjust other bands.
Repeat steps 3 to 5 for each band so
that the desired tone can be obtained.
. Store the adjusted equalizer curve in
memory.
The adjusted equalizer curve wil! be
reset when another equalizer curve is
recalled. If you want to retain the
adjusted curve, store it in the memory
of this unit.
(Refer to the following section.)
Storing Equalizer Curves
The equalizer curves adjusted by the user
can be stored as the user's curves in the
memory under 4 buttons [8].
Storing a User's Curve in Memory
1. Adjust an equalizer curve as desired.
(Refer to "Adjusting the Equalizer
Curve" on page 29.)
2. Press and hold one of (U1) to (U4) of
buttons [8] that you want to store the
equalizer curve for more than 2
seconds.
(One of "USER 1 — 4" indicators [21]
blinks during storing and lights up after
completion of storing.)
*
Equalizer curves can be stored in either
the nuance control mode or 3-band
parametric equalizer adjustment mode.
*
{fan equalizer curve has already been
stored under the button, the previous
memory is cleared and the new
equalizer curve is stored in memory.
¢
When a equalizer curve is stored, its
nuance control value is set to 0.
Advertisement
Table of Contents
