Troubleshooting; Causes And Remedies - Dometic RM 2410 Installation And Operating Instructions Manual

TROUBLESHOOTING
A. Burner jet clogged.
Remove the burner jet. Soak the jet in wood alcohol
and blow it out with compressed air. Do not use a
wire or pin to clean the burner jet.
Refrigerator not level.
Flame has gone out.
Remedy: 1) Gas in bottle is used up-refill. 2) The tip
of the flame failure safety device is not heated
enough by flame. 3) Clogged by-pass screw - clean
or exchange it.
Venting problem.
Restriction in air flow across cooling unit.
Heavy frost buildup on evaporator fins.
Defrost.
Flue baffle not inserted properly in flue tube.
Improperly set thermostat.
See paragraph on thermostat. In hot weather the
setting should be closer to MAX than usual.
H. Burner dirty.
Clean.
|. Burner damaged.
Replace.
J. LP gas pressure low at burner.
Set main regulator so the pressure does not drop
below 11 inches water column at pressure tap.
K. Burner not located properly under flue tube.
Relocate.
mo on
on
ODOR FROM FUMES
Causes and remedies
A. The flame touches side of the boiler due to disloca-
tlon of the burner. Relocate. Burner dislocation may
also cause smoke and discoloring of walls and ceil-
ing.
B. Burner damaged. Replace.
C. The flue tube Is dirty. Clean flue as follows:
Cover burner and burner jet. Remove the flue cap
from the top of the flue tube and lift out the wire and
spiral baffle. Clean the flue from the top using a flue
brush. Clean the spiral baffle. Replace the spiral baf-
fle and the flue cap.
All the above instructions are to be followed closely. The
refrigerator is quality-guaranteed. However, we are not
responsible for any failures caused by improper adjust-
ments and unfavorable installation conditions. Contact
service point or distributor service dept. for assistance.
Replacement Parts Suppliers: See page 1.
15