User Educational Requirements; Operation Of Psds With Harris Radios; Basic Psds Set-Up; Amplifier/ Radio Assembly Installation - Pts AS0117-HR-117G/152 Manual

Document PTS-HR-117G/152-2019-4-8

User Educational Requirements

Prior to use of the PSDS, the user should have completed the Harris Operators Course.
The user should have a thorough understanding of Harris operations and a basic
understanding of the AN/PRC 117G or AN/PRC 152 set-up and configurations.

Operation of PSDS with Harris Radios

SAFETY NOTICE: Power down the radios and ensure the PSDS power switch is in the
off position prior to installing or connecting radios. Failure to do so can result in
electrical shock.

Basic PSDS Set-Up

Amplifier/ Radio Assembly Installation

Facing the PSDS take one RF-300M-*** and insert onto the PSDS. Begin by looking
down from the top to align the power amplifier's rear connector with the PSDS
connector. Lock the amplifier in place by turning the knurled thumbscrew clockwise to
seat the amplifier. Repeat this process to mount the amplifier on the left side.
Antenna & Handset Installation, Radio Configuration
To ensure proper operation an OE-254/GRC antenna (not the manpack antenna) must
be connected to the amp or you will experience excessive noise. Connect the antenna
connector to the installed amplifier. The user needs to place the antenna 100 feet away
from the PSDS using the LMR-400 antenna cable. Attach the appropriate handset.
Inspect the AC power cable for cuts, frays or other damage. If damaged, replace the
power cable. Plug the appropriate power cable into the back of the PSDS and into the
AC power source (grid or generator power, worldwide). You are now ready to perform
radio operations.
Note: The PSDS provides worldwide auto switching power adjustment. As long as the
proper power cable is used for the AC power source, the PSDS will automatically adjust
to the provided input. If the power is "dirty" and experiencing fluctuations, the PSDS will
continually adjust for these changes.
PTS, Inc. 6