Operation - Makita RP0900 Instruction Manual

OPERATION

Set the tool base on the workpiece to be cut without
the bit making any contact. Then turn the tool on and
wait until the bit attains full speed. Lower the tool body
and move the tool forward over the workpiece surface,
keeping the tool base flush and advancing smoothly
until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
4
1
2
3
► 1. Workpiece 2. Bit revolving direction 3. View from
the top of the tool 4. Feed direction
NOTE:
• Moving the tool forward too fast may cause
a poor quality of cut, or damage to the bit or
motor. Moving the tool forward too slowly may
burn and mar the cut. The proper feed rate will
depend on the bit size, the kind of workpiece
and depth of cut. Before beginning the cut on
the actual workpiece, it is advisable to make a
sample cut on a piece of scrap lumber. This will
show exactly how the cut will look as well as
enable you to check dimensions.
• When using the straight guide, be sure to install
it on the right side in the feed direction. This
will help to keep it flush with the side of the
workpiece.
1
► 1. Feed direction 2. Bit revolving direction
3. Workpiece 4. Straight guide
2
4
2
4
Straight guide
The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bars into
the holes in the tool base. Adjust the distance between
the bit and the straight guide. At the desired distance,
tighten the wing bolts to secure the straight guide in
place.
1
► 1. Guide bar 2. Clamp screw 3. Straight guide
When cutting, move the tool with the straight guide flush
3
with the side of the workpiece.
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight
guide, or if the side of the workpiece is not straight, the
straight guide cannot be used. In this case, firmly clamp
a straight board to the workpiece and use it as a guide
against the router base. Feed the tool in the direction of
the arrow.
A
6 ENGLISH
2
3