Table of Contents
Advertisement
Chapter 1 Maintenance
[?]
Recovering from a Red Screen of Death (RSOD) screen.
Are the installed memory and PCI device supported by the device?
□
→
The functionality of devices other than those specified by our firm cannot be guaranteed.
□ Update the components, if an update is available for any of the following components:
- PCI device firmware
- iLO firmware
- System ROM
□ Have you changed the server configuration/settings or the system status?
If you have changed the server configuration/settings or the system status, a Red Screen of Death
→
(RSOD) screen appears in rare cases before starting up the OS. This may cause the server to become
uncontrollable. However, the server may recover from the RSOD by turning off and then on the power
again.
[?]
IML message "209 - Unsupported DIMM Configuration Detected - Installed DIMM configuration does NOT
support configured AMP Mode. System will operate in Advanced ECC Mode" is displayed during POST
Did you change the DIMM configuration?
□
→
If the "Fault Tolerant Memory (ADDDC)" mode is used, refer to Chapter 2 DIMM of the User's Guide
and change it to a DIMM configuration that supports the "Fault Tolerant Memory (ADDDC)" mode.
If the "Fault Tolerant Memory (ADDDC)" mode is not used, perform setting by following the steps
→
below.
1.
Press the <F9> key during POST to start System Utilities.
2.
Change "Workload Profile" to "Custom".
3.
Set "Advanced Memory Protection" to "Advanced ECC Support" mode.
Exsample of Red Screen of Death (RSOD) screen
Express5800/R120h-1M, R120h-2M (2nd-Gen) Maintenance Guide
5. Troubleshooting
31
Advertisement
Table of Contents
