Sealey SCR01B Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. safety
Warning! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this stool.
‰
locate stool in a suitable working area.
9
Warning! Use stool on level and solid ground, preferably concrete.
‰
Keep the stool clean and tidy in accordance with good workshop practice.
9
do not use the stool for any purpose other than that for which it is designed.
8
do not stand on the stool.
8
do not use the stool outdoors.
8
do not get the stool wet or use in damp or wet locations or areas where there is condensation.
8
do not clean the stool with any solvents which may damage the plated surface or the protective coating on the padded seat base.
8
2. introduction
Four legged heavy-duty steel construction with a clack powder coat finish for corrosion resistance. Strengthening rings for stability, acts as a
foot rest. Ø430mm Swivel seat features pneumatic height adjustment (660 to 800mm), rotates fully through 360° and is padded with high back
for extra comfort.
3. sPecification
model no: ............................................................. scr01b
Capacity: ...................................................................... 150kg
Height(s): ............................................................ 660-800mm
4. assembly
4.1. Unpack all parts before disposing of packaging material according to local
recycling regulations.
4.2. Slide components together.
5. oPeration
5.1. once the stool is assembled, compress the height adjustment lever whilst
the seat is unloaded. This will allow the seat to reach its maximum height.
5.2. To adjust the height, pull the switch lever slowly whilst sitting on the seat.
Release the lever when at the desired height.
6. maintenance
6.1. If in constant use, check the tightness of all fixings on a weekly basis.
6.2.
Clean the seat cushion and trays with a moist cloth and mild detergent.
© Jack Sealey limited
Pneumatic WorkshoP stool With
adjustable height sWivel seat & back
rest
scr01b
Model no:
Original Language Version
fig.1
SCR01B Issue 1 06/12/19