Download Print this page
Sealey LED109 Series Manual
Sealey LED109 Series Manual

Sealey LED109 Series Manual

10w smd led rechargeable portable floodlight

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1.
SAFETY
1.1.
GENERAL
Ensure the floodlight is fully charged before use.
9
DO NOT turn the floodlight on when it is being charged.
8
DO NOT shine directly into your, or another person's or an animal's eyes.
8
DO NOT allow children to use the floodlight.
8
DO NOT handle or move the floodlight when it is being charged.
8
DO NOT use the floodlight if you suspect that the battery or the floodlight casing is damaged.
8
DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage fully recharge the battery,
8
subsequently recharge the battery at least every six months of non use.
1.2.
ELECTRICAL SAFETY FOR USE OF CHARGER
USE ONLY THE SUPPLIED CHARGER FOR CONNECTING FLOODLIGHT TO THE POWER SUPPLY.
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be incorporated into the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical supply
not protected by an RCCB.
You must also read and understand the following instructions concerning electrical safety.
1.2.1. The Electricity At Work act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable appliance Tester (PAT), at least once a year.
1.2.2. The Health and Safety At Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the charger plug, cable and connector for wear and damage to ensure that items are safe before connecting to the mains
power supply. If worn or damaged do not use.
IMPORTANT: Check that the voltage marked on the charger plug is the same as the floodlight.
1.2.4. Uncoil the cable between the charger and the floodlight.
DO NOT pull the charger plug from the mains socket by the lead.
8
WARNING! DO NOT use any other type of charger with this product, other than the supplied mains or car charger. Failure to observe
this warning could result in injury and or fire and will invalidate the warranty.
DO NOT try to take the charger plug apart.
8
DO NOT use the charger plug to charge or power any other electrical item.
8
DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).
8
1.3.
BATTERY SAFETY
WARNING! to reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Replace only with the battery pack designed for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
© Jack Sealey Limited
10W SMD LED RECHARGEABLE PORTABLE
FLOODLIGHT
LED109 SERIES
MODEL NO:
Original Language Version
LED109 SERIES
Issue 3 (H,2,3,4,F)
14/06/23

Advertisement

loading

Summary of Contents for Sealey LED109 Series

  • Page 1 LED109 SERIES MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 Under these circumstances we will not replace the battery even if it is less than one year old. fig.1 fig.2 fig.3 Original Language Version LED109 SERIES Issue 3 (H,2,3,4,F) 14/06/23 © Jack Sealey Limited...
  • Page 3 5.1.4. Undo the 2 battery retaining screws (fig.3.A) and remove the battery retainer. 5.1.5. Unplug the battery cable from the circuit board. 5.1.6. Remove the old battery and replace with a genuine Sealey battery and install by reversing the above procedure. Note: Take care not to pinch any wires.