Sealey WORKSAFE SSP19CO Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
WARNING! Put the ear defenders on before exposing yourself to noise and wear them during the whole noise exposure. Be
‰
warned that failure to adhere to these recommendations will cause the protection afforded by the product to be severely impaired.
Regularly check for serviceability.
9
Ear defenders may be adversely affected by certain chemical substances. Further information should be sought from manufacturer of the
9
chemicals that they may come into contact with.
Ear defenders and in particular the cushions, may deteriorate with use and should be examined at frequent intervals for cracking and
9
deterioration. Replace after 2 to 3 years of normal use or sooner if there are any signs of deterioration.
DO NOT replace any parts, there are no replacement parts.
8
The fitting of hygiene covers to the cushions may affect the acoustic performance of the ear defenders.
9
Ear protection will be reduced if the defenders are not well fitted and not regularly checked.
9
If the recommendations given in the instructions are not followed, the protection provided by the ear defenders will be significantly
9
reduced.
WARNING! These ear-defenders are of universal size range. Ear-defenders complying with EN 352-1 are of universal size range.
‰
Universal ear-defenders include small, medium and large size and are thus designed to fit the majority of wearers including for those
whom medium size does not fit.
2. INTRODUCTION
Lightweight, yet rugged construction, certified to BS EN 352-3:2002 standard. Hearing protection level in excess of the standard, with an SNR of
30dB. Fully adjustable ear cups to ensure a precise seal against the head. Suitable for use on all Worksafe helmets or any helmet with a 30mm
fixing point. Fully approved to protect against high noise levels in most working environments. Nett weight: 295g
3. ATTENUATION VALUES
4. USE
A. Attach ear defenders to each side of the hard hat by sliding them into the slots.
B. Slide each ear defender housing down into the slots on each side of the helmet.
C. Place hard hat on head and adjust the ear defenders by sliding cups up and down.
D. Ensure the ear defenders are firmly attached by lifting the arms up and down.
E. To remove, push clip outwards from inside the helmet and pull from the helmet.
© Jack Sealey Limited
DELUXE CLIP-ON EAR DEFENDERS
SSP19CO
MODEL NO:
Original Language Version SSP19CO Issue:1 08/07/20