Stinger UV-15, UV-40, UVB45, UV-801 - Electronic Insect Killer Manual
![]()
IMPORTANT SAFETY INSTRUCTIONS
Please read these instructions before using the Stinger Electronic Insect Killer and keep for future reference.
- This product is equipped with a 2-prong plug to fit the proper type receptacles. To reduce the risk of electrical shock, only plug into a properly installed outlet.
- Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
- Collected insects within the unit may contribute to fire so clean dead insects from the unit frequently.
- Do not clean this product with water spray or any other liquids. Do not place where it can fall into water, or near flammable materials.
- Store product indoors when not in use – out of reach of children.
- Always disconnect plug before servicing, cleaning, changing bulbs and when not in use.
- Do not abuse cord – never carry unit by cord or unplug unit by pulling on the cord - only unplug by pulling on the plug. Keep cord away from heat, oil, or sharp edges.
- Extension cords used with this product must be marked with suffix letters "W-A" and with a tag stating "Suitable for Use with Outdoor Appliances".
- Use only extension cords that have plug and receptacles that match the product plug.
- Electrical rating of the extension cord must be as great as theelectrical rating of the product.
- There are devices available for retaining a connection between an extension cord and a power supply cord. Connections should be kept off the ground and dry.
- Do not mount the unit on house, other buildings, on decks or nearheat, gas, oil or other flammable materials.
- For outdoor residential use only.
The Stinger Electric Insect Killer is designed to lure and kill a wide range of flying insects. The ultraviolet (UV) light given off by this unit is within the luminescent range proven effective to lure these insects. Insects are lured to the light and killed as they contact the electrically charged inner grid area. Insects fall through the open base onto the ground. The outer protective cage helps prevent pets, birds, butterflies, and children's fingers from contacting the charged grids. The unit is for outdoor use only and can withstand moderate rain. For best results, the unit should be installed in early spring and left on continuously through the season.
CHOOSING A LOCATION
When selecting a location, you want to remember the insects will be lured to the unit so do not put the unit near human activity. Choose a location about 25 feet away from the area you are trying to protect. If there is a water source nearby, place the unit between you and the water because water is often a breeding ground for flying insect pests. Depending on the model number, the unit is designed to cover areas up to 1/2 acre (UV15), 1 acre (UV40/UVB45), and 1 1/2 acre (UV801). (Fig. 1)
![]()
INSTALLATION/OPERATION
- Unpack unit, save all packaging material for off-season storage.
- Select the proper location to hang your unit using the information above. For Model UVB45 – use the bonus cord included in the box to hang the unit.
- Hang the unit approximately 7 feet above the ground from a tree, mounting pole or other free standing object. Never mount the unit from house or other building.
- Plug cord into a compatible extension cord rated for outdoor use.
- The unit will be on once it is connected to an electrical source. This unit does not have an "on/off" switch. Please allow up to 5 minutes for the bulb to light completely.
- This unit is designed to withstand moderate rain but should be taken down and stored indoors during severe weather.
- It is recommended that this unit be put to use in early spring and left out until late fall to maximize effects.
- Using the available lures (see "accessories") will add to the effectiveness of the unit by adding a chemical scent to attract more insects to the unit.
- Model UVB45 has 2 settings – 24 Hour Operation or Automatic Operation. (Fig. 2)
- To select 24 Hour Operation, slide the grey button on the cap down into the
mode. The unit will remain on 24 hours a day. - To select Automatic Operation, slide the grey button on the cap up into the
mode. The unit will turn on automatically at dusk, operate through the night and turn off in the morning.
INSTALLING THE NOSQUITO MOSQUITO OCTENOL LURE
You will find a Nosquito octenol lure (NS16) included with most Stinger Insect Killers. Research has shown that octenol is effective in attracting many species of mosquitoes and biting flies. This lure has slow release properties and increases the effectiveness of luring mosquitoes to the unit. For best results, replace every 30 days.
- Open lure by either removing lure from pouch or peeling off the foil lid.
- Models UV15, UV40 and UVB45 have a specially designed holder built into the base. Simply push the lure into this holder. The lure should fit snuggly and the tension tabs should hold it tightly in place. (Fig. 3)
![]()
- To remove – spread the tension tabs with your fingers, pull out the lure and discard appropriately in a trash receptacle.
- Model UV801 unit has a small cassette which holds the lure. Simply place the lure into the cassette and attach to the body of the cage.
CHANGING BULBS
Only use Stinger™ replacement bulbs. These bulbs have an average life of 1000 hours and should be replaced annually to maintain optimal UV effectiveness. Even though the bulb' s light may be visible to you, its ability to attract insects diminishes over time. If the bulb fails to light or the color of the light changes to yellow or orange it is time to replace the bulb. (Fig. 4)
![]()
- Unplug and remove entire unit from hanging position.
- Turn unit upside down, open the bulb cap and remove old bulb.
- Insert the new bulb making sure it is properly seated in the socket.
- Close the bulb cap by snapping it into place.
- Place unit back into the hanging position and plug back into the outlet.
Note: If unit fails to light after replacing bulb, take unit down and remove the bulb and reseat it in the socket.
CLEANING
As the unit kills insects, most of the insect remains will be vaporized or fall down through the unit. Some remains may be left on the grids and over time may reduce the effectiveness of this device. Make sure to regularly clean your unit to achieve maximum effectiveness. The time in between each cleaning will vary depending on your insect populations. Check your unit frequently and clean any insect remains you see.
- Unplug and remove entire unit from hanging position.
- Remove bulb from unit to avoid damage (see above instructions).
- Using a small brush or stick, gently remove any insect remains from outer casing and inner grids.
- If available, you may use compressed air to clean out your unit.
- Never use water to clean your unit, water could damage the electrical components.
- Be very careful not to move the grids from the seatings.
- Once the unit is clean, replace the bulbs, return the unit to the hanging position and reconnect to power source.
Note: If arcing occurs after cleaning, unplug unit and remove from hanging position. Check the grids and make sure they are not touching in any place. Gently use a stick to bend grids away from each other.
TROUBLESHOOTING
Symptom: | Solution: |
Unit will not light, no apparent grid voltage | - Make sure unit is plugged into working outlet.
|
Unit will not light, grid has voltage | - Check bulb to make sure it is seated properly.
- Replace bulb if necessary.
|
Unit will light, no apparent grid voltage | - Unplug unit and check grids to make sure they are not touching and seated properly. Adjust as needed.
|
Unit appears to be working properly but insect populations do not seem reduced | - Check grids and make sure there is voltage.
- Check surrounding area for sitting water, insects breed in these areas and should be eliminated from the source.
- Allow more time; it will take some time for the insects to find the unit and also for there to be an impact on their reproductive cycles.
- Try moving the unit to another area of the yard. If you are in between the unit and the source of the insects, they will have to fly by you to get to the unit and you may actually notice an increase in insects.
|
Unit is constantly arcing (sparking) | - Clean unit per the instructions in the "Cleaning" section of this manual.
- Check the grids and make sure they are not touching, adjust as needed.
|
If the above troubleshooting doesn't solve your problems or you have any other questions, please call consumer relations at 800-477-0457 or email consumerrelations@kaz.com.
PRODUCT SPECIFICATIONS
Model | UV15 | UV40/UVB45 | UV801 |
Acreage | Up to 1/2 acre | Up to 1 acre | Up to 1 1/2 acre |
Unit Wattage | 35 | 70 | 152 |
Unit Voltage | 120 | 120 | 120 |
Unit Amps | 0.3 | 0.6 | 1.3 |
Replacement Bulb Model | B1515 | B4040/B4045 | B8080 |
Bulb Wattage | 15 | 40 | 80 |
Grid Voltage | 3000 | 4000 | 4200 |
3 YEAR LIMITED WARRANTY
This Electronic Insect Control Device is warranted against defective material or workmanship for a period of three years from the date of purchase. Any defective part will be, at the discretion of Kaz, repaired or replaced at no charge if the appliance has not been tampered with and has been used according to these printed directions. The consumer is responsible for charges incurred for shipping the defective unit to Kaz for repair/replacement. Retain your receipt to prove warranty. This warranty gives you specific legal rights as well as other rights that vary from state to state.
If you experience unsatisfactory operation, first refer to the "Troubleshooting" section of this manual and follow those suggestions. If Troubleshooting doesn't work, please contact Kaz for repair instructions.
If you have questions of comments, please call Kaz at 800-447-0457 or email consumerrelations@kaz.com. Please do not return this product to the store. Contact Consumer Relations - we can help you.
ACCESSORIES
PART | DESCRIPTION |
B1515 | 15 Watt Replacement bulb for UV15 |
B4040 | 40 Watt Replacement bulb for UV40 |
B4045 | 40 Watt Blacklight Replacement bulb for UVB45 or UV40 |
B8080 | 80 Watt Replacement bulb for UV801 |
NS16 | NOsquito Mosquito Lure |
MP84 | Mounting Pole |
Kaz also manufactures devices made for indoor insect control. Please visit www.kaz.com or call consumer relations for more information about these devices.
TO ORDER ACCESSORIES:
Telephone: Call 800-477-0457 with your Visa, MasterCard or Discover.
Online: Visit www.kaz.com with your Visa, MasterCard or Discover.
Fax: 508-481-0509. Include part number, quantity, shipping information, telephone number, Visa, MasterCard or Discover number, expiration date, and name on the card.
Mail: Send check or money order to:
Kaz, Incorporated
Consumer Relations Dept
250 Turnpike Road, Southborough, MA 01772 Include $4.95 for shipping and handling. Add applicable taxes in MA, NY and TN
Orders are generally received 7-10 days after being placed. Please allow 2-6 weeks for mailed in orders.
Kaz, Incorporated
250 Turnpike Road, Southborough, MA 01772
800-447-0457
www.kaz.com
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Stinger UV-15, UV-40, UVB45, UV-801 - Electronic Insect Killer Manual
Need help?
Do you have a question about the UV-15 and is the answer not in the manual?
Questions and answers