(2) Installing a main memory
⚫
The orientation of a main memory module on a connector is fixed. When you
install a main memory module, make sure the orientation is correct.
Otherwise, failure of the equipment may result.
⚫
Do not install main memory modules with different capacities in slot A1 and slot
B1, or in slot A2 and slot B2. If you do, the modules may not be recognized.
[1] Follow the instructions in "6.3.3 Installing and removing the cover of the equipment" to
remove the cover of the equipment.
[2] Refer to the figure below and remove the SATA cables from the backboard connectors.
NOTICE
Figure 6-4
Removing the SATA cables
6-13
6. CHECKUP AND MAINTENANCE
Silk printing
SATA1
connector
Note: When installing the SATA cables,
check the silk printing on the
cables and attach them to the
corresponding connectors.
SATA0
connector