Table of Contents
Advertisement
Operating Manual
MHM-97442
5
Configuration
The following chapter describes the configuration of the A6370 monitors with the
AMS 6300 Configuration software. Download the software by using the link (see
5-1) on the CD which is part of the configuration kit "A6910 Configuration Kit".
Alternatively enter
into the address bar of your internet browser. Beside this, the configuration kit contains an
USB interface cable for the connection of a computer to the configuration interface of the
monitor and measuring cables to check sensor signals and pulses.
Note
The software AMS 6300 Configuration can also be used to configure CSI 6300 SIS
monitors.
Figure 5-1: CD index with link for downloading the configuration software
5.1
Configuration procedure
For the operation of the AMS 6300 SIS it is required to enter all operation parameters
according to the requirements and to load them to the monitor.
Ensure that AMS 6300 Configuration is installed on the computer for the parameter input.
The configuration can be performed offline that means without connection to the monitor
or online with an interface connection to the monitor. Always load the configurationto the
monitor. Each of the three monitors has to be configured separately. All safety relevant
parameters except the trigger thresholds have to be set identically in the three monitors
(A, B, and C). The following steps must be carried out:
MHM-97442, Rev. 2.06
http://reliabilitymobile.com/apps/registration/Account/Login.aspx
Configuration
February 2023
Figure
69
Advertisement
Table of Contents
