Sealey VS0031.V3 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure all Health & Safety, local authority, and general workshop practice regulations are strictly adhered to when
‰
using this product.
WARNING! Ensure the engine and cooling system has cooled, before opening the radiator cap.
‰
Maintain tools in good and clean condition for best and safest performance. DO NOT use tester if damaged.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
9
Keep yourself, tools, and test equipment away from hot engine parts.
9
DO NOT use this tool for any purpose other than that for which it is designed.
8
Never lay tools on the vehicle's battery. This may short the terminals together, causing harm to yourself, the tools, or the battery.
8
Account for all tools and parts being used and DO NOT leave any in the engine bay.
9
Keep children and other unauthorised persons away from the working area.
9
Keep test kit parts clean, store parts in the carry case, and keep this in a safe, dry, childproof location.
9
DO NOT run engine while pressure testing.
8
DO NOT use in radiators or header tanks with internal neck diameters greater than 45mm.
8
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual to establish the current
procedure and data. These instructions are provided as a guide only.
2. INTRODUCTION
Capless cooling system tester uses an inflatable bladder to seal the pressure head to the radiator or header tank. Bladder system can be used
on both screw and bayonet fittings and seals 90% of cars and light commercial vehicles straight out of the box. Also suitable for motorcycles,
off-road and marine applications. Supplied with set of double end adaptors enabling testing of cooling system pressure caps. Supplied in
storage case.
3. APPLICATIONS
Pressure Cap Test; Standard Bayonet (Ford, GM N Body), External Thread (Jeep, Saab, VW/Audi), Internal Thread (Small Japanese Deep,
VW/Audi), Internal Thread (Small Japanese Shallow, Late Model VW/Audi), External Thread (Late Model BMW, Land Rover), External Thread
(Late Model Mercedes), Pressure System; Universal
© Jack Sealey Limited
COOLING SYSTEM & CAP TESTING KIT
MODEL NO:
Wear protective Hot surfaces
gloves
Original Language Version
VS0031.V3
VS0031.V3 Issue 1 24/03/22