Bellfires UNICA-2 90 Instructions For Use & Manual Daily Maintenance page 17

Bellfi res
AM
PM
ON
OFF
1 2
Note
Change from two-button to one-button ignition operation by pressing
and holding
ON is displayed and 2 is fl ashing. When change is complete 2 will
change to 1.
Important: • If the pilot fl ame goes out for any reason, wait for 5 minutes
before attempting to re-light it.
• If the pilot light does not ignite after 3 ignition attempts;
close the gas tap and warn the fi tter.
• Once the pilot light is burning, the main burner must ignite
within 10 seconds automatically.
If this does not happen, immediately close the gas tap and
warn the fi tter.
• If the main burner ignites with a pop; immediately close the
gas tap and warn the fi tter.
Instructions for use
Hand-Held Transmitter Two-Button Operation
• Press
two short beeps and a blinking series of lines
confi rms the start sequence has begun; release
buttons.
• Main gas fl ows once pilot ignition is confi rmed.
• Hand-held transmitter automatically goes into
Manual Mode after main burner ignition.
button for 10 sec. immediately after installing batteries.
and button simultaneously until
English
17