Installation; Installation Location - Miele FNS 4382 E edt/cs Operating Instructions Manual

Installation

Installation location


Risk of damage due to high
humidity.
In environments with high humidity,
condensation can build up on
external refrigeration appliance
panels.
This condensate can cause corrosion
on external appliance panels.
Install the refrigeration appliance in a
dry and/or air-conditioned room with
sufficient ventilation.
After installation, please make sure
that the appliance door(s) closes/
close properly and that the specified
ventilation gaps are adhered to.

Fire hazard and risk of damage
from appliances that give off heat.
Appliances that give off heat can
catch fire and set fire to the
refrigeration appliance.
Do not place appliances which give
off heat, such as mini-ovens, double
burner cooktops or toasters on the
refrigeration appliance.

Fire risk and danger of damage
from open flames!
Open flames can set fire to the
refrigeration appliance.
Keep open flames (e.g. a candle)
away from the refrigeration
appliance.
18
This appliance should be installed in a
dry, well-ventilated room.
When deciding on the installation site,
please bear in mind that your
refrigeration appliance will use more
energy if installed near to a heater, a
cooker or other appliance that gives
off heat.
Avoid direct sunlight.
The higher the ambient temperature,
the longer the compressor runs and
the higher the energy consumption is.
When installing the refrigeration
appliance, please note the following:
- The mains socket must not be
located directly behind the appliance
and should be easily accessible.
- The plug and mains connection cable
must not touch the rear of the
refrigeration appliance as they could
be damaged by vibrations from the
appliance.
- Other appliances must also not be
plugged into a socket located directly
behind this appliance.
- WARNING: When positioning the
appliance, ensure the mains
connection cable is not trapped or
damaged.
- WARNING: Do not locate multiple
portable socket-outlets or portable
power supplies at the rear of the
appliance.
- The floor at the installation site must
be horizontal and level and must be
as high as the surrounding floor.