General safety To minimise the risk of fire Maintenance and Care, 6 Switching off the electricity Cleaning the filter after each cycle FTVF XT 75B Check the drum after each cycle Cleaning the dryer Dryer description, 7 The front The back...
Installation Where to put your dryer ! Ensure that the end of the tube is not directed toward the air intake vent at the rear of the dryer. Place your dryer at a distance from gas ! The vent tube should not exceed 2.4 metres in ●...
Installation Open window venting ! Do not use extension cords. ! The power cord must not be bent or The end of the tube squashed. should be directed ! The power cord should be regularly downwards, to prevent checked. If the supply cord is damaged, it warm moist air from must be replaced by the manufacturer, its condensing in the room or...
Warnings ! The appliance has been designed and Check to see if the dryer is empty before ● loading it. built according to international safety The back of the dryer could standards. ● become very hot. Never touch it These warnings are given for safety while in use.
Warnings To minimise the risk of fire in your or explosive substances. Highly flammable tumble dryer, the following should be substances commonly used in domestic observed: environments including cooking oil, Tumble dry items only if they have been acetone, denatured alcohol, kerosene, ●...
Maintenance and Care Switching off the electricity 3. Replace it correctly. Ensure the filter is fully located flush into the tumble dryer Unplug your dryer when not using it, when trim. cleaning it and during all maintenance operations. 4. Remove any lint that has built up on the inside of the door and around the door seal.
Dryer Description The front The back Air Intake Vent Rating plate Model & Serial Control Panel numbers Vent Tube fitted here Drum Caution: Hot! Filter Control panel Indicator Key Lock CLEAN FILTER HEAT LEVEL PROGRAMME Button & Light Icon Button & Lights knob Display Unit &...
The Display The Display has three main functions, each with its corresponding button. Dryness Sensing Levels After selecting a programme that has a Sensor Dry option, press and release the button until the required dryness sensing level is displayed. If the sensing option is not available with your selected programme, the display will flash and the buzzer will beep three times.
Start and Programmes Choosing a programme your laundry and take out items that are dry 1. Plug the dryer into the electrical socket. while others continue drying. When you close 2. Sort your laundry according to fabric type (see the door again, press the START/PAUSE button in Laundry).
Page 10
Start and Programmes Shirts High heat option This is a programme for shirts made from cotton. ● It can be used for load sizes up to 3kg (approximately 10 shirts). ● The duration of this programme will depend on the size of the load, the dryness setting selected and the spin ●...
Page 11
Start and Programmes Wool Programme This is a programme for tumble dryer safe garments marked with the symbol ● It can be used for load sizes up to 1kg (approximately 3 sweaters). ● We recommend that garments are turned inside out before drying. ●...
Page 12
Start and Programmes Programmes Table READY TO WEAR - Programme Options available Dryness Levels available ✓ ✓ - High An Automatic programme Dry from Damp ● - Medium ✓ ✓ - High An Automatic programme ● Business Week - Medium ✓...
Start and Programmes The Controls Sound If selected, gives a signal at the end of the drying cycle, Programmes knob ● to remind you that the clothes are ready to be removed. ! Warning, if after pressing the START/PAUSE button Note: If you have selected the Crease Care option this the programme knob position has changed, the new option is not available.
Laundry Sorting your laundry Drying times Check symbols on clothing labels to make sure The table (see below) presents APPROXIMATE drying ● that the articles can be tumble dried. times in Minutes. Weights refer to dry garments. Sort laundry by fabric type. ●...
Troubleshooting One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The tumble dryer won’t start. The plug is not plugged into the socket, or not making contact. ●...
Rest assured though, no one knows a Hotpoint appliance better than we do and our service is second to none... Wherever you are we can be there - we have over 1,000 highly skilled Hotpoint engineers covering the whole of the UK and Ireland ensuring fast, reliable, local service.
Product Data... (EU Regulation 392/2012) Brand Hotpoint Models TVF ET 75B TVF XT 75B FVFET 75B Rated capacity of Cotton laundry for the standard programme at full load 7 kg Energy efficiency class B The weighted Annual Energy Consumption (AE ) 471.8 kWh...
Need help?
Do you have a question about the FTVF XT 75B and is the answer not in the manual?
Questions and answers