Table of Contents
Advertisement
Chapter 3 Setup
3.
EXPRESSSCOPE ENGINE 3
3.1
Overview
EXPRESSSCOPE Engine 3 provides a variety of features using BMC (Baseboard Management Controller),
which is a system management LSI.
See EXPRESSSCOPE Engine 3 User's Guide for detailed information.
EXPRESSSCOPE Engine 3 monitors the power supply unit, fans, temperature, and voltage of the server. If you
have the management LAN port connected to the network, you can remotely perform the following over a web
browser or SSH client:
Manage the server
Remotely control the keyboard, video, and mouse (KVM)*
Remotely access a CD/DVD/floppy disk/ISO image/USB memory*.
* To enable this feature, the optional license for remote management (N8115-04) is required.
To actualize these functions, virtual USB mass storage (Remote FD, Remote CD/DVD, Remote USB Memory,
or Virtual Flash) is always connected as USB mass storage.
3.2
EXPRESSSCOPE ENGINE 3 Network Configuration
Take the steps below to use EXPRESSSCOPE Engine 3 through the Web browser.
1.
Run POST following Chapter 3 (1.1.1 POST sequence). Wait until the following message appears on the
lower left of the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
2.
Press the <F4> key while the message is being displayed to launch ROM Utility.
3.
Select your keyboard type on Keyboard Selection screen.
118
Important
This server does not support the Memory Throttling feature.
Express5800/T110i-S User's Guide
3. EXPRESSSCOPE ENGINE 3
Advertisement
Table of Contents
