Page 1
Instruction Manual 3” X 21” BELT SANDER Model 909.25722 • Safety WARNING: • Operation Before using this product, • Maintenance read this manual and follow • Parts List all its Safety Rules and • Français Operating Instructions. Sears Canada Inc., Toronto, M58-2B8 Form No.
SEARS WARRANTY Full three year warranty on your Craftsman Tool If this Craftsman tool fails due to a defect in material or workmanship within three years from the date of purchase Sears will repair it free of charge. WARRANTY SERVICE IS AVAILABLE BY RETURNING THE TOOL TO THE PLACE OF PURCHASE OR NEAREST SEARS SERVICE CENTER.
CAUTION: Wear appropriate hearing for this tool that are sold by Sears or a protection during use. Under some Craftsman outlet. Use of any conditions and duration of use, noise from accessories purchased elsewhere may this product may contribute to hearing be hazardous, and will also void your loss.
Page 4
Lower voltage will cause loss of power The filter should be replaced daily or and can result in over-heating. All whenever the wearer has difficulty Craftsman tools are factory-tested; if this breathing. tool does not operate, check the power NOTE: Only those dust masks suitable supply.
Page 5
Extension Cords in the uppermost position, this cover can be raised as shown in Figure 2 Make sure the extension cord is in good (Arrow 1) and locked in place to: condition before using. Always use the proper size extension cord with the tool – a.) Improve accessibility to narrow areas.
Page 6
sanding belt runs outward, turn the tracking adjustment knob clockwise to correct. If belt runs inward turn adjustment knob counterclockwise. Belt life will be greatly increased by keeping the tracking adjustment set properly. To prevent the sanding belt from rubbing against the sander housing, keep the edge of the belt about 7/64”...
Variable Speed Switch - Figure 11 OPERATION The variable speed feature of your belt sander allows you to increase or Operating Position- Figure 8 Always hold belt sander firmly with both decrease the speed of the belt by turning the speed wheel as shown in Figure 11. hands while sanding as shown in Figure 8.
Page 8
Accessories Use only 3” x 21” (76 x 533mm) sanding belts. Use only Craftsman accessories with your tool. These accessories are available at extra cost from your local Sears store or Sears Parts and Repair Center.
Page 11
Get it fixed, at your home or ours! Just Call: 1-800-4-MY-HOME ® (1-800-469-4663) 24 hours a day, 7 days a week For the repair of major brand appliances in your own home … no matter who made it, no matter who sold it! For your nearest Sears Parts &...