Advertisement
Quick Links
Advertisement
Related Manuals for Comfast CF-XR186
Summary of Contents for Comfast CF-XR186
- Page 1 Wireless Expander/ Repeater ：V1.0 ersion...
- Page 2 Introduction 1.1、Product Structure: Power indicator: Blue is always on to indicate the power is on Network port status light: Blue is always on to indicate normal network cable access WiFi status light: Steady red indicates that the trunk signal is weak Steady blue indicates that the trunk signal is strong...
- Page 3 "COMFAST_XXXX_2G" or "COMFAST_XXXX_5G" 2.2. Click the WiFi signal "COMFAST_XXXX_2G" or "COMFAST_XXXX- _5G" to pop up the login interface, enter the password "admin" in the password box, and click "Set Password". 10:03 10:03 192.168.10.1 COMFAST XXXX English admin COMFAST XXXX Set Passwor d Tip: When logging in for the first time, the login interface will pop up automatically.There are two cases when there is no login interface:...
- Page 4 SIDD name after one relay in the list box. Sync your device: Turn on this option, the new WiFi name will be the same as your original WiFi name, no need to reset the extended WiFi name. COMFAST-XXXX-2G COMFAST-XXXX COMFAST-XXXX...
- Page 5 Introduction to working mode 3.1. The software has four working modes, including relay mode, bridge mode, AP mode, routing mode (PPPoE dial-up, static IP, dynamic IP). 3.2. Bridge mode settings: Find and set in Advanced Mode 3.3. AP mode setting: Enter the software management page, click AP mode, in order to facilitate management, the IP address and default gateway entered here should be the IP network segment of the upper-level router, and the IP address cannot conflict with the IP of the upper-level...
- Page 6 3.5. Routing mode setting: Enter the software management page, only the routing mode is displayed, click the routing mode, and you can choose three Internet access modes: "PPPoE", "Static IP" and "Dynamic IP". 1, PPPOE dial-up mode: In this mode, you need to fill in the Internet account and password provided by the network service provider.
-
Page 7: Ipv6 Setting
IPv6 Setting Click and select to enter the IPv6 setting page. IPv6 Status: Displays the information about the IPV6 address obtained by the device. IPv6 Setting: Set the IPV6 LAN and WAN information. Mesh Setting Precautions: 1. The Mesh controller node needs to be enabled in Router mode or AP mode. - Page 8 Click and select Enter to enter the Mesh setting page. EasyMesh status: After the Mesh is successfully formed, view the schematic diagram of the Mesh. Controller Agent Mobile phones and other devices connected to the Mesh network EasyMesh settings: 1. Select the role of Mesh. 2.
- Page 9 Mesh pairing: After enabling Mesh, a button for Mesh pairing will appear on the page. On the pages of the two nodes, click the "Trigger easymesh" button to start building Mesh. Light control status You can turn off the lights in advanced settings. NOTE: The power light cannot be turned off.
- Page 10 Q：What’s the role of WiFi extender? A：Boost the range of your existing WiFi and creates stronger signal in hard-to-reach areas.Please note that it can’t increase your wifi speed of your router, the speed of the extending wifi willbe reduced. Q：Where shall I place the WiFi extender? A：We would suggest that after setting up successfully, please move this wifi extender on the halfway between your router and your weak signal area.
- Page 12 / www.szcomfast.com...
Need help?
Do you have a question about the CF-XR186 and is the answer not in the manual?
Questions and answers