Table of Contents
Related Manuals for Canon EOS 5D Mark IV + 70-200mm
Summary of Contents for Canon EOS 5D Mark IV + 70-200mm
- Page 1 Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Canon EOS 5D Mark IV + 70-200mm o cerca il tuo prodotto tra le migliori offerte di Fotocamere Digitali EF70-200mm f/2.8L IS III USM Instructions...
- Page 2 Thank you for purchasing a Canon product. Canon’s EF70-200mm f/2.8L IS III USM is a Camera Firmware telephoto lens for use with EOS cameras. Please use the latest version of firmware with the camera “IS” stands for Image Stabilizer. in use. For details on whether the firmware is the latest ●...
-
Page 3: Safety Precautions
Safety Precautions Precautions to ensure that the camera is used Details pertaining to risks that may Caution safely. Read these precautions thoroughly. Make result in injury. sure all details are observed in order to prevent Do not leave the camera in locations subject to ●... -
Page 4: General Precautions
General Precautions Handling Precautions If the lens is taken from a cold environment into a ● ● warm one, condensation may develop on the lens surface and internal parts. To prevent condensation in this case, first put the lens into an airtight plastic bag before taking it from a cold to warm environment. - Page 5 This device complies with Part 15 of the FCC Rules. CAN ICES-3 (B) / NMB-3 (B) Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 6 Nomenclature Focusing distance range selector switch (→ 7) Distance scale (→ 9) Hood mount (→ 14) Zoom ring (→ 8) Rubber ring (→ 6) Filter mounting thread (→ 15) Contacts (→ 6) Focusing ring (→ 7) Lens mount index (→ 6) Focus mode switch (→...
-
Page 7: Mounting And Detaching The Lens
If the rubber ring becomes worn, it is replaceable by a Canon Service Center at a cost. After detaching the lens, place the lens with ●... -
Page 8: Setting The Focus Mode
2. Setting the Focus Mode 3. Switching the Focusing Distance Range To shoot in autofocus (AF) mode, set the focus mode switch to AF. You can set the focusing distance range with a To use only manual focusing (MF), set the focus switch. - Page 9 4. Zooming To zoom, turn the lens’ zoom ring. Be sure to finish zooming before focusing. Zooming after focusing can affect the focus. ENG-8...
-
Page 10: Infrared Index
5. Infinity Compensation Mark 6. Infrared Index Infinity compensation mark Distance scale Infrared Index Distance scale Distance index The infrared index corrects the focus setting when To compensate for shifting of the infinity focus using monochrome infrared film. Focus on the subject point that results from changes in temperature, manually, then adjust the distance scale indicated by there is a margin at the infinity (∞) position. -
Page 11: Image Stabilizer
7. Image Stabilizer You can use the image stabilizer in AF or MF mode. Set the STABILIZER switch Select the stabilizer mode. When you press the to ON. shutter button halfway, the MODE 1: Corrects vibrations ● ● Image Stabilizer will start If you are not going to use the ●... -
Page 12: Tips On Using The Image Stabilizer
8. Tips on Using the Image Stabilizer The image stabilizer for this lens is effective for hand-held shots in the following conditions. MODE 1 MODE 2 ■ ■ In semi-darkened areas such as indoors or When panning subjects in motion. ●... - Page 13 Tips on Using the Image Stabilizer The Image Stabilizer cannot compensate for a Using a tripod also stabilizes the image. ● ● ● ● blurred shot caused by a subject that moved. However, depending on the kind of tripod and Set the STABILIZER switch to OFF when you shooting conditions, sometimes it may be better ●...
-
Page 14: Tripod Mount
9. Tripod Mount This lens can be used with the included B (W II) tripod mount ring. Detaching First remove the lens from the camera and then remove the tripod mount from the lens as shown below. To attach the tripod mount, reverse the procedure. Lock knob Loosen the orientation lock Rotate the tripod mount and... - Page 15 10. Hood The ET-87 hood cuts out unwanted light and protects the front of the lens from rain, snow, and dust. Attachment position mark Red dot Red dot Red dot Attachment position mark Stop position mark Button ● Attaching ● Removing Align the red attachment position mark on the Keep your finger pressed down on the button hood with the red dot on the front of the lens,...
- Page 16 II for magnified shots. The focusing distance and magnification are shown below. Only one filter may be attached. ● ● If you need a polarizing filter, use the Canon ● ● Focusing Distance Magnification (×) Circular Polarizing Filter PL-C B (77 mm).
- Page 17 14. Extenders (Sold Separately) Lens specifications when using extender EF1.4x III or EF2x III are as follows. Item Extender EF1.4x III Extender EF2x III Focal length (mm) 98 - 280 140 - 400 Aperture f/4 - 45 f/5.6 - 64 Diagonal 25°20′...
-
Page 18: Specifications
The size and weight listed are for the lens only, except as indicated. ● ● Aperture settings are specified on the camera. ● ● All data listed is measured according to Canon standards. ● ● Product specifications and appearance are subject to change without notice. ● ●... - Page 19 CT1-D058-A 0518Ni © CANON INC. 2018...