Assembling The Selfie Stick; Attaching A Smartphone To The Selfie Stick - Silvercrest 288654 Operating Instructions Manual

NOTE
► Press and hold the On/Off button
stick for 2 seconds to turn on the Bluetooth
function. The Bluetooth
times. The charging status LEDs
then go off after about 35 seconds. The devices
are now connected via Bluetooth
have to confirm the Bluetooth
your smartphone.
Assembling the selfie stick
♦ Screw one of the threads on the mount
thread of the tripod head
mount
position using the fastening screw
♦ Push the telescopic shaft
selfie stick handle. Turn the telescopic shaft
wise a little until the telescopic shaft
the selfie stick. The telescopic shaft
selfie stick are now connected to each other.
Attaching a smartphone to the selfie stick
♦ Open the mount
♦ Place your smartphone into the mount
♦ Release the clip so that the clip snaps onto your
smartphone. Ensure that your smartphone is firmly
in place in the mount
♦ Set the vertical tilt angle of the smartphone. Loosen
the fastening screw hinge joint
turning it anticlockwise. Lock the smartphone into
this position by turning the fastening screw hinge
joint clockwise.
♦ Set the horizontal alignment of the smartphone.
Undo the fastening screw
ing it to the right. Turn the fastening screw
left to lock the smartphone into this position.
│ GB │ IE │ NI
■ 10
vertically or horizontally. Fix the required
by pulling the spring clip open.
LED flashes three
®
light up and
connection on
®
. You can assemble the
into the holes on the
.
on the mount by
on the mount by turn-
SSP 2600 A1
of the selfie
®
. You may
®
onto the
.
clock-
clicks into
and the
.
to the