Heatstore AQUA PROFILE PLUS AQP8 Installation Instructions & User Manual page 11

Plumbing Connections
Hole Cover Fitting
Top left entry: Depending on your choice of cold-water
entry direction, you may need to remove thin areas of plastic
cover to facilitate pipe work entry down through the top left
of the unit.
Bottom entry: Depending on your choice of cold-water
entry direction, fit 'hole covers' to the pipe work slots at the
bottom of the unit.
Note: The grey areas shown are tabs that can be removed to
allow 6mm cable entry only.
Water Connection
The inlet pipe connection into the elbow is a self-seal push-
fit type. All burrs and rough edges must be removed from
the end of the pipe before connecting.
To release the pipe work from the push-fit type fitting, press
and hold the collet against the elbow and pull the pipe out
of the elbow.
Turn on the water supply and inspect for water leaks at the
shower inlet. Once inspected-turn off the water supply.
Pressure Relief Device (PRD)
A pressure relief device is designed into this shower.
The pressure relief device provides protection should an
excessive build up of pressure occur within the shower unit.
It is advisable to position the shower unit over a bath or
shower tray to contain water released in the unlikely event
the device should discharge.
Do not use the shower with a damaged or kinked shower
hose or blocked handset. This may trigger the PRD which
will discharge through the vent in the bottom right hand
corner (shown).
In the event of the PRD activating, water will be discharged
from the vent. If this happens, switch off the electricity and
water supplies to the shower and contact your point of
purchase.
Need help? For further technical help or advice please contact your point of purchase.
cont.
Back of unit
Pull collet
back towards
elbow
Pull pipe
from elbow
Pipe
cover
Blanking
cover
Collet
PRD Vent
11