Before Turning On The Power; Initial Auto Installation - Sharp TU-T2 Operation Manual

Quick guide

Before turning on the power

Connect the antenna (standard DIN45325 plug (IEC 169-2)
75 q coaxial cable)
Connect the HDMI cable
Connect the p ower adapter

Initial auto installation

When the Receiver is powered on for the first time after purchase, the first time installation screen appears. Follow the
on-screen instructions to search for all available channels.
Confirm the following before turning on the power
Is the antenna cable connected?
E
Is the power adapter connected and plugged in?
E
Is the HDMI cable connected between the Receiver and your TV?
E
1 a on the Receiver.
Press
The first time installation screen is displayed.
•
2
Ensure the antenna cable is connected.
3
Press OK to start the channel search.
The Receiver will search for, sort and store all
•
receivable channels.
NOTE
• The first time installation process will be aborted if the
Receiver is left unattended for more than 30 minutes before
searching for channels.
• After the first time installation has been completed, the
default PIN is automatically set to '0000'. To change the PIN
setting, refer to Page 20.
TU-T2_GB.indd 9 TU-T2_GB.indd 9
RF IN
USB
RF OUT
ETHERNET SPDIF HDMI VCR
12V DC - 2A
-
TV +
Place the TV close to the AC outlet,
and keep the power plug within
reach.
First Time Installation
Please ensure that an aerial is connected
Then press to scan for services
OK
9
01/06/2010 16:02:54 01/06/2010 16:02:54