Belt And Stabilizer Guide Brackets - Lippert SMART BED UNIVERSAL KIT Oem Installation Manual

Belt and Stabilizer Guide Brackets

Belt Brackets
NOTE: The proper belt bracket locations will depend on the type of Smart Bed Lift configuration and where
the motor is installed.
1.
Measure from the corner edge out on the end rail with the supplied measurements for each Smart Bed
Lift model. This measurement will be from the corner to the outside edge of the belt bracket.
2.
Align the strap mounting bracket drill fixture with the marked location on the end rail frame. Make sure
the fixture's drill hole guide is facing outward.
3. Use a 5/32" drill bit to pre-drill the side hole (Fig. 16A) for the #9 rivet.
4.
Remove the strap mounting bracket drill fixture.
5.
Align the side hole in the belt bracket (Fig. 16A) with the pre-drilled hole in the end rail.
6. Use a pneumatic rivet gun with an extended tip to secure a #9 rivet (Fig. 16B) into the side of the belt
bracket and the rail.
7.
Repeat steps 3-7 for all belt brackets.
8.
Pre-drill the top hole of the belt bracket closest to the outside of the end rail (Fig. 17B).
9.
Secure the top of the belt bracket with a #9 rivet (Fig. 17A).
10. Repeat steps 8-9 for the remaining belt brackets.
Rev: 12.28.22
Fig. 16
A
B
Page 10
Fig. 17
A
B
CCD-0004051