Advertisement

VMS User Manual
1
2
3
Arrowes Roading Safety | 17 Bailey Court Brendale Q 4500 | P: (07) 3881 3302 |
6
3
4
6
7
8
User manual

Operational Guidelines

Standard operations
Refer to touch screen controller shown on the left:
Button
1
to switch the VMS display between Amber only
mode or PENTA (5 color) mode.
5
Button
2
to switch VMS display off, but touch screen con-
troller stays on (use power switch on the right side of the
controller to completely power off the system).
Keypad
3
(the message list with number codes should be provided
by the manufacturer). Used SET button after keyed in
number code.
Navigation buttons
out number codes. Selected message number code is
shown in between the buttons.
Preview screen
When the screen is in grey color, this indicates button
switched and VMS display is off.
Note:
Preview screen mimics what is displayed on the VMS.
When system is powered off, last selected states and
messages are remembered and retains when power on.

Radar settings

9
To enter radar setting press button 6. the screen will change to
radar setting screen show on the second image.
There are
3
settings for the radar:
-Radar On/Off button 7, pressing this button will allow the ra-
dar to be enabled or disabled.
10
-Speed limit text box 8, pressing this text box allows the speed
to be set using the Keypad 3. A green on the bottom of the text
indicates the text box is selected.
-warning message text box 9, pressing this text box allows the
warning message to be set by using Keypad 3. A green on the
bottom of the text indicates the text box is selected.
Note: use message print out code to select which message to
be set and shown when detection speed is over the set limit.
Press button 6 to return to main VMS screen. Third image on
the left shows when detected speed
the set warning message (message 414) will be displayed
instead of the standard message. This message display for at
least 3 seconds and stays displayed until speed is under the
limit again and standard message is displayed.
to key in number codes for selected messages
4
are used to selected messages with-
5
displays current selected message.
10
is over the limit and
www.arrowes.com.au
2
is
Page | 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VMS and is the answer not in the manual?

Questions and answers

Summary of Contents for ARROWES VMS

  • Page 1 This message display for at least 3 seconds and stays displayed until speed is under the limit again and standard message is displayed. Arrowes Roading Safety | 17 Bailey Court Brendale Q 4500 | P: (07) 3881 3302 | www.arrowes.com.au Page | 1...
  • Page 2 Power Earth in cable 2 core, DIN 7 connector Data cable VMS Board RJ 45 5 core cable Chassis Earth Arrowes Roading Safety | 17 Bailey Court Brendale Q 4500 | P: (07) 3881 3302 | www.arrowes.com.au Page | 2...
  • Page 3 Power‐off VMS when replacing VMS panels Step 1: Remove the faulty panel Unlatch VMS frame door latches located on the bottom of the VMS, then open door. Refer to image below of the marked clips and screws on red: ‐ Unscrew the 2 x marked screws in blue.
  • Page 4 VMS User Manual Warranty The Arrow Emergency Systems VMS is supplied with a limited ex- factory warranty for 12 months. Arrowes Roading Safety | 17 Bailey Court Brendale Q 4500 | P: (07) 3881 3302 | www.arrowes.com.au Page |...

Table of Contents