Table of Contents
Advertisement
>>
Using a PC
<<
Control of the TV (Continue)
Command format
Eight ASCII codes +CR
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0–9, x, blank, ?
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4
values are input for the parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response
code format".)
Any numerical value can replace the "x" on the table.
Response code format
Normal response
Problem response
(communication error or incorrect command)
Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM
POWER SETTING *2
INPUT
TOGGLE
SELECTION
TV
*1 Select "Initial Setup" from the menu screen and set "Quick Start Mode" to "On" to enable the
Power On command for LAN and Wi-Fi.
When "Quick Start Mode" is set to "Off" and "Wake on Wi-Fi/LAN" is set to "Enable", you can use
"Wake on LAN (Magic Packet)" to turn on the power via LAN.
When "Quick mode" is "Off" and the power of the display is off, you can use only "POWR1"
command by setting the baud rate as "9,600" on PC side.
After using "POWR1" command, the baud rate becomes the original setting before turning off the
display.
*2 The minijack (Terminal: "SERVICE ONLY") outputs the system boot message for service other
than command response when the TV turns on / off. Please ignore the system boot message.
NOTE
If an underbar (_) appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL
CONTENTS.
Any numerical value can replace the "x" on the table.
ENG 7-2
COMMAND PARAMETER
CONTROL CONTENTS
P O W R 0
_
_
_
Power
It shifts to standby.
Off
1
_
_
_
Power
Power On *1
On
I
T G D _
_
_
_
(Toggle) It input-switches by the toggle.
(It is the same as an input
change key)
I
T V D 0
_
_
_
It input-switches to TV. (A
channel remains as it is. (Last
memory))
Advertisement
Table of Contents
