NEC UNIVERGE SV9100 System Maintenance Manual page 48

Issue 1.0
SV9100 N
S 7
ECTION
Enter
NWINFO
To display the syntax for each command – type in the command.
Example:
nwinfo parkhold
NWINFO PARKHOLD DEL
NWINFO PARKHOLD SHOW
NWINFO PARKHOLD MODE
NWINFO PARKHOLD DEBUG
NWINFO PARKHOLD CLEAR
nwinfo parkhold del
NWINFO PARKHOLD DEL
(The values within the brackets are the specific number related to the command, the brackets are not
entered.)
In the NWINFO PARKHOLD DEL command to delete park hold orbit 04 that is within park group 01 you
would enter: nwinfo parkhold del 01 04
nwinfo debug on should only be used in the lab (or after normal working hours at a customer site), as it
causes a large amount of information to be output and can slow the SV9100.
3 - 10
DIM C
ET OMMANDS
Function
Lists the NWINFO DEBUG
commands NWINFO RSRC
available NWINFO BLF
NWINFO TCPINIT
NWINFO TCPDEBUG
[ON|OFF]
NWINFO TCPSHOW
NWINFO CALLINFO
NWINFO KEEPALIVE
NWINFO SYSTEM
NWINFO OPCHG
NWINFO PARKHOLD
NWINFO CALLID
NWINFO CHSHOW
NWINFO ROAMING
NWINFO TASKINIT
NWINFO TASKKP
NWINFO VMI
DIM Output
Networking Debug Information [ON|OFF]
Netport Reosurce Controller
Blf Memory Dump
Dummy CR data send Task refresh
Networking TCP Information Debug
Networking TCP Information showing
Networking Call Status Information
Networking KeepAlive Information
Networking System Information
Networking error operation change
Parkhold debug information
Networking CallID mode selection
Show ch condition LED on Dterm
PHS Roaming Debug
NwInfoSend task initialize
Nwsend Task Keepalive setting
Remote VMI information
Deletes the specified parkhold
Shows the specified parkhold information
Changes Networking Parkhold mode [RUN|STOP]
Park Hold Trace Information [ON|OFF]
Park Hold Clear at All of systems
<park group no> <park orbit>
UNIVERGE SV9100