Advertisement
Industry Canada Equipment Attachment Limitations
The Industry Canada label on equipment means it has been tested and found to meet
requirements for telecommunications operation and safety in Canada. The label does
not guarantee, however, that the equipment will operate to your satisfaction.
Repairs to certified equipment should be made by an authorized Motorola agent. If
the equipment malfunctions due to any unauthorized repair or alteration, the
telecommunications company may request that you disconnect the equipment.
Ensure that connection to local telecommunications company facilities is permissible
and that the equipment is installed properly. Compliance with the above conditions
may not prevent degradation of service in some situations.
Ground connections for power and telephone lines should be wired to a single
ground line. This may be particularly important in rural areas. These connections
should be made by a qualified electrician. If already installed, the connections should
be inspected by the appropriate electrical inspection authority.
To prevent circuit overload, each piece of equipment is assigned a Load Number
(LN), which denotes the percentage of the total load used by the device in a
telephone loop. This equipment has a load number of 4. You may use any
combination of devices on a loop, subject only to the requirement that the total of
the load numbers of all the devices does not exceed 100.
The standard connecting arrangement codes for the equipment are as follows:
CA02B, CA11A, CA40A, CA41A, and CA45A.
Canadian Emissions Statement
This Class A digital apparatus meets all requirements of the Canadian Interference
Causing Equipment Regulations.
Cet appareil num
sur le mteriél brouilleur du Canada.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
é
rique de la classe A respecte toutes les exigences du R
èglement
Country-Specific Information C-29
Advertisement
Chapters
Troubleshooting
