Preparation; Unpacking The Tv - JVC LT-24C655C Instruction Manual

24" led smart hd tv with built-in dvd player
Table of Contents

Advertisement

Chapter
2

Preparation

2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Unpacking the TV

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
GB
GB
Instruction Manual
24" LED Smart HD TV with built-in DVD player
LT-24C655(C) / LT-24C656(C)
Instruction Manual
LT-24C655/656(C)_IB.indd 9
for purchasing your new JVC TV.
TV Stand
3
Installing the Base Stand
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table, with the back side
Quick Start Guide
facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is placed beneath the screen.
3. To install, slide the TV stand into the slot on the bottom of the TV. Make sure it clicks into position.
For wall mounting instructions please refer to your Instruction Book.
24" LED Smart HD TV
with built-in DVD player
LT-24C655(C) / LT-24C656(C)
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your
viewing experience. We would suggest that you allow about 20 mins
for initial setup.
Please follow this guide for a successful first time installation.
Cushioned
material
The latest eco-friendly power-saving technology will switch off
the TV if device is left on and idle for 4 hours. Please refer to "Auto
Standby" under the "Time Settings" section of the instruction
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
manual for more detail.
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
1
Unpacking
4
Connecting the Aerial and Turning on the TV
TV
R emote Control/
Instruction Manual
Remove all packaging from the unit. Retain the packaging.
AAA Batteries x2
TV Stand
Quick Start Guide
If you dispose of it please do so according to any local regulations.
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on
the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on. The red LED indicator will flash for a few
Please inspect your TV for damage after unpacking. If you do notice any damage please consult your dealer.
seconds then the TV will switch on.
2
Operating Your Remote Control
1. Slide open the battery compartment on the back of the
remote control.
LAN
SPDIF
VGA
Coax.OUT
SCART
2. Insert two AAA size batteries. Make sure to match the (+)
and ( - ) ends of the batteries with the (+) and ( - ) ends
indicated in the battery compartment.
3. Slide the battery compartment cover back into place.
• Do not connect the TV to the mains supply until you have completed all the connections.
Make sure it clicks into place.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
LT-24C655_656(C)_QSG.indd 1
Quick Start Guide
SCART
LAN
SPDIF
VGA
Coax.OUT
SCART
Table
Optional
If you want to connect to the internet via a wired connection
then connect your ethernet cable to the LAN socket.
LAN
SPDIF
VGA
RF coaxial cable
Coax.OUT
(not included)
SCART
18/10/2016 15:30
2
3
.,/@
ABC
DEF
4
5
6
GHI
JKL
MNO
7
8
9
PQRS
TUV
WXYZ
0
TV
V
P
OK
EPG
TXT
LANG.
SUBT.
Remote Control /
AAA Batteries x 2
9
26/04/2017 14:39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lt-24c655Lt-24c656Lt-24c656c

Table of Contents