Sealey VSE6541 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective
‰
Equipment is available from your Sealey Stockist.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to
‰
when using tools.
DO NOT use tools if damaged.
8
Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9
Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9
Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage
9
after use.
IMPORTANT! These Instructions are provided as a guide only. Always refer to the vehicle manufactures' service instructions or a
proprietary manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator/
‰
user must apply caution and common sense (good practical sense).
When timing an engine, always prevent the engine from being turned over. Use a notice and/or inhibit the engine.
9
WARNING! Incorrect or out of phase camshaft timing can result in contact between the valve head and the piston crown. This will
‰
cause damage to the engine.
2. INTRODUCTION
Essential tool for removing/installing the high pressure fuel pump. Time saving tool as the fuel pump drive gear retains its timed position when
pump is removed. Supplied in a storage case with full instructions.
3. CONTENTS
4. APPLICATIONS
MAKE MODEL
Ford: Edge (18-21)
Transit (16-23)
Tourneo Custom (16-23)
Transit Custom (16-23)
© Jack Sealey Limited
HIGH PRESSURE FUEL PUMP REMOVER/
INSTALLER - FORD 2.0D ECOBLUE
VSE6541
MODEL NO:
ENGINE CODE(S):
2.0D EcoBlue: BC2X, BCCA, BCCB, BCFA, BCFC, BCFD, BCRA, BJFA,
BJFB, BKFA, BKFB, BKFC, BKFD, BJRA, BLFA, BLFB, BLHA,
BLRA, YL2X, YLFA, YLFB, YLFS, YLF6, YLRA,YMFS, YMF6,
YMFA, YMFB, YMHA, YMR6, YMRA, YNF6, YN2X, YNFA,
YNFB, YNFS, YNRA, YLR6, YNR6.
Original Language Version
Item Part Number Description
1 VSE6541.01 Fuel Pump Removal/Installation Plate
2 VSE6541.02 Plate Bolts 6mm x 30mm (3)
3 VSE6541.03 Stepped Bolts (3)
4 VSE6541.04 Nuts 6mm (3)
5 VSE6541.05 Forcing Screw
6 VSE6541.06 Cover
7 VSE6541.07 Installation Bolt
VSE6541 Issue 2 14/07/23