Table of Contents
Advertisement
Central remote controller
Changing air conditioner Settings (Set Temperature, Operation Mode, Fan
Speed, and Louver)
You can change the set temperature, operation mode, fan speed, and louver.
Depending on the range of the area to be set, display and operate the "Control" screen of All, Zone, or Unit.
1
No.
Item
1
Set temperature
2
Operation mode
3
Fan speed
4
Louver
20
-EN
1
2
3
2
3
4
You can change the set temperature using [∧] and [∨].
●
NOTE
• The set temperature cannot be changed when the operation mode is Fan.
• The temperature range that can be set differs depending on the operation mode.
• If a temperature outside the set temperature range of the relevant operation mode is set, the
temperature is changed to the upper- or lower-limit temperature of the range.
You can change the operation mode using [∧] and [∨].
AUTO
●
NOTE
The operation modes that cannot be set are not displayed.
You can change the fan speed using [∧] and [∨].
●
NOTE
• The fan speeds that cannot be set are not displayed.
• A blank is displayed if the fan speed is fixed.
You can change the louver to the following, using [∧] and [∨].
Swing
Swing stopped
Operation Mode
Auto (Cool), Cool, Dry
Auto (Heat), Heat, Fan
●
NOTE
• The louver position may differ for the header and follower units.
• The setting range differs depending on the operation mode.
Display the "Control" screen of All, Zone, or Unit (P.13)
Use [<] and [>] to select the item to change.
For details of the setting of each item, see the table below.
Make changes using [∧] and [∨], and then press [
• The changes to the settings are not reflected on the air conditioner
unless you press [ ] (Confirm).
Description
HEAT
COOL
F1
Swing → Swing stopped → F1 → F2 → F3 → Swing (back to
the beginning)
Swing → Swing stopped → F1 → F2 → F3 → F4 → F5 →
Swing (back to the beginning)
FAN
F2
F3
Setting range
Owner's Manual
] (Confirm).
DRY
F4
F5
Advertisement
Table of Contents
