Connection To The Mains; Power Supply Of Further Devices; Operation; Stand-Alone Operation - EuroLite LED TMH-X4 User Manual

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket.
2 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.

Power supply of further devices

The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the device starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.

Stand-alone operation

In stand-alone mode, the LED TMH-X4 can be used without controller. Disconnect the LED TMH-X4 from the
controller and call up the internal program. Please refer to the instructions under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode "Slow", "Fast", "Sound" or "Manual" for the master device. Set the respective
mode "DMX" for all slave-devices. Please refer to the instructions under Control Board.

DMX-controlled operation

You can control the devices individually via your DMX controller. Every DMX channel has a different
occupation with different features. The individual channels and their features are listed under DMX protocol.
The device has two DMX channel modes. The Control Board allows you to assign the DMX channel mode.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-X4 will respond to the controller.
If you set, for example, the address in the 24 channel mode to channel 25, the LED TMH-X4 will use the
channel 25 to 48 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-X4 correctly
and independently from any other fixture on the DMX-chain. If several LED TMH-X4 are addressed similarly,
they will work synchronically.
24/32 00143830, Version 1.1