Configure Network/Monitor Ports On The G-Tap A-Tx - Gigamon G-TAP A 1 Series Hardware Installation Manual

G-TAP A Series 1 Hardware Installation Guide
passwd Changes the password on the G-TAP A Series node.
reboot Reboots the G-TAP A Series node. The CLI gives you the option of
performing a Warm or Cold reboot:
Warm Reboot – Network/Monitor ports are not affected.
l
l
re-established.
show Shows current settings on the G-TAP A Series node. You can use this
command with any of the following arguments:
batteryex – Shows the four last records of the BET.
l
diag – Provides detailed summary of current settings, operational
l
parameters, and statistics.
Note: The show diag command reports CRC errors differently on the G-
TAP A-TX and G-TAP A-SF taps:
G-TAP A-TX: CRC errors for network ports are reported for diagnostic
l
purposes.
G-TAP A-SF: CRC errors are not reported.
l
port-params – Shows Link, Auto Negotiation, Link Speed, and
l
Duplex settings for the Network and Monitor ports.
G-TAP A-TX: dip_sw – Shows the current settings of the DIP switches
l
on the rear of the tap.
snmp – Shows configured trap destinations and available trap
l
events.
system – Shows detailed system configuration information,
l
including network settings for the Mgmt port and the On/Off status
of primary power sources.
time or date – Shows time/date configured on the G-TAP A Series
l
node.
Command History
The G-TAP A Series 1 CLI remembers the last 10 commands you entered, allowing you scroll
through previous commands with the up and down arrow keys.

Configure Network/Monitor Ports on the G-TAP A-TX

The G-TAP A-TX is shipped with autonegotiation enabled on the Network/Monitor ports and
can be used out of the box by simply supplying power and connecting network cables.
Connect and Configure G-TAP A Series 1 Nodes
Cold Reboot – Link connectivity interrupted until power restored and links
25