Table of Contents
Advertisement
34 Electrical installation
Twist the shield to form a PE conductor, and mark it with yellow-green tape or
heat-shrink tubing.
5.
For each cable, attach cable lugs at the end of the PE conductor (twisted shield)
and current conductors.
4
WARNING!
Apply grease to stripped aluminum conductors before you attach them to
non-coated aluminum cable lugs. Obey the grease manufacturer's
instructions. Aluminum-aluminum contact can cause oxidation in the
contact surfaces.
6.
For each cable, attach the conductive sleeve (a) to the bare cable shield with a
cable tie. Attach the cable to the support bracket with a clamp (b).
5
b
a
Advertisement
Table of Contents
