Table of Contents
Advertisement
the appliance. Clean and dry the interior thoroughly. To prevent odor and mold
growth, leave the door slightly open.
MOVING THE WINE COOLER
Remove all items.
Take out the loose items inside the wine cooler (such as shelf) or fix the loose items
with foam.
Turn the adjustable leg up to the base to avoid damage.
Tape the door shut.
Be sure the appliance stays secure in an upright position during transportation. Also
protect the outside of appliance with a blanket or similar items.
ENERGY SAVING TIPS
The wine cooler should be located in the coolest area of the room, away from
producing appliances and out of the direct sunlight.
E. TROUBLESHOOTING GUIDE
Problem
Wine Cooler does not
operate
Wine Cooler is not
cold enough
Compressor turns on and
off frequently
The light does not work
Vibrations
Too much noise
-
The plug is not plugged into the socket properly.
-
The appliance is switched off.
-
There is a power cut.
-
Temperature control setting is not set properly.
-
The door is opened too often.
-
The door is not closed completely.
-
The door gasket does not seal properly.
-
The appliance has been installed near a heat source.
-
The room temperature is hotter than normal.
-
The cabinet is overloaded.
-
The door is opened too often.
-
The door is not closed completely.
-
Temperature control setting is not set correctly.
-
The door gasket does not seal properly.
-
The plug is not plugged into the socket properly.
-
There is a power cut.
-
The bulb has burned out.
The light button is "OFF"
-
-
The wine cooler is not installed on a level surface.
-
The rattling noise may come from the flow of the
refrigerant, which is normal.
-
As each cycle ends, you may hear gurgling sounds
caused by the flow of the refrigerant.
-
The wine cooler is not correctly installed.
-
The wine cooler is not installed on a level surface.
Possible Cause
Advertisement
Table of Contents
