Advertisement
Quick Links
Advertisement
Related Manuals for Husqvarna LC 519AP
Summary of Contents for Husqvarna LC 519AP
- Page 1 LC 519AP, LC 521SP Operator's manual 2-17...
-
Page 2: Table Of Contents
The grass is collected in a grass catcher. other tasks. Remove the grass catcher to get rear discharge of the grass. Attach a mulch kit to cut the grass into fertilizer. Product overview LC 519AP LC 521SP 1. Handle / handlebar 13. Rear cover 2. Throttle control 14. - Page 3 Read the operator's manual carefully Do not breathe in exhaust fumes. and make sure that you understand the The exhaust fumes from the engine instructions before use. contain carbon monoxide, an odourless, poisonous and very dangerous gas. Do not start the engine indoors or in closed Keep persons and animals at a safe spaces.
-
Page 4: Safety
Be careful when you go near hidden corners and you are not sure how to operate the product in a objects that prevent a clear view. special situation, stop and speak to your Husqvarna dealer before you continue. Work safety •... - Page 5 If the engine does not stop, do these steps: Personal protective equipment a) Disconnect the ignition cable from the spark plug to stop the engine. WARNING: b) Let an approved Husqvarna service agent adjust Read the warning the throttle control. instructions that follow before you use the product.
-
Page 6: Assembly
Husqvarna service agent. • Do not smoke near the fuel or the engine. • Let an approved Husqvarna service agent do • Do not put warm objects near the fuel or the engine. servicing on the product regularly. •... - Page 7 (Optional accessory) To assemble the grass catcher (LC 1. For LC 519AP, remove the engine cover. 519AP) 2. Remove the screws that holds the muffler cover. 3. Remove the muffler cover.
-
Page 8: Operation
7. For LC 519AP, attach the engine cover. Operation Introduction 2. Fill slowly with a fuel can. If you spill fuel, remove it with a cloth and let remaining fuel dry off. WARNING: Before you operate the product, you must read and understand the safety chapter. - Page 9 To install the grass catcher To change the product to rear discharge mode (LC 521SP) 1. Lift the rear cover. 1. Lift the rear cover (A) and remove the mulch plug or the grass catcher. 2. Hold the grass catcher at the grass discharge channel.
- Page 10 3. Move the throttle control to the fast speed position. • If the engine does not stop, disconnect the ignition cable from the spark plug. 4. Hold the starter rope handle with your right hand. 5. Slowly pull out the starter rope until you feel some resistance.
-
Page 11: Maintenance
Maintenance Introduction For more detailed information, refer to www.husqvarna.com. WARNING: Maintenance schedule Before you do maintenance, you must read and The maintenance intervals are calculated from daily use understand the safety chapter. of the product. The intervals change if the product is not used daily. - Page 12 4. Put the dipstick fully into the oil tank. Tighten the oil CAUTION: If the product is put tank cap to make sure to give a correct picture of the with the air filter down, the engine can oil level. become damaged.
- Page 13 1. Push the latch tabs (A), remove the air filter cover Note: Always replace a damaged air filter. (B) and remove the air filter (C). To remove and install the air filter WARNING: Use protective gloves. 1. Push the clips on the air filter cover. 2.
-
Page 14: Troubleshooting
• If the spark plug is dirty, clean it and make sure that • The product moves slowly when the drive of the the electrode gap is correct, refer to . wheels is engaged. For the situations that follow, it is necessary to extend the length of clutch wire: •... - Page 15 Problem Possible cause Solution The engine does not operate The ignition cable is not connected cor- Connect the ignition cable to the spark smoothly. rectly. plug. There is dirt in the fuel line or the fuel Clean the fuel line. Fill the fuel tank with has expired.
-
Page 16: Transportation, Storage And Disposal
Discard the fuel at • When the product is no longer in use, send it to an applicable disposal location a Husqvarna dealer or discard it at a recycling • Safely attach the product during transportation to location. - Page 17 LC 519AP LC 521SP Spark plug Husqvarna HQT-7 Husqvarna HQT-7 Electrode gap, mm 0.7–0.8 0.7–0.8 Engine lubrication type Splash Splash Fuel and lubrication system Fuel tank capacity, l Oil tank capacity, l Engine oil Husqvarna SAE 30/SAE Husqvarna SAE 30/SAE...
- Page 18 1904 - 002 - 04.11.2022...
- Page 19 1904 - 002 - 04.11.2022...
- Page 20 Original instructions 1143007-26 2022-11-04...