Craftsman 152.213371 Owner's Manual page 15

FOROPERATOR S AFETY, keepfingers andaHH foreign
objects outoftheintakeports. T herotating faninside
theMower h ousing is accessibHe through the intake
portsandis hazardous. DonotwearHoose cHothing or
jeweHry. Makecertain thateachintakeportwhichis not
beingusedor attached to a dustcoHHection system is
covered withan intake portcap.
CONNECTING TOOL TO
POWER SOURCE
A separate eHectricaHcircuit shouHd be used for your
tooHs.This circuit shouHd not be Hessthan #14 A. W. G.
wire and shouHd be protected with a 15-amp time Hag
fuse. Have a qualified eHectrician repair or repHace dam-
aged or worn cord immediately. Before connecting the
motor to the power Hine, make certain the switch is in
the "OFF" position and be sure that the eHectric current
is of the same characteristics as stamped on the motor
namepHate. AHH Hineconnections shouHd make good con-
tact. Running on HowvoHtage wiHH damage the motor.
DO NOT EXPOSE THE DUST COLLECTOR TO RAmN
OR OPERATE THE MACHmNE mNDAMP LOCATmONS.
START/STOP SWITCH
Fig. 18
\
The START/STOP switch is Hocated on the side of the
motor. To turn the dust coHHector"ON", push the green
start button (A). To turn the dust coHHector"OFF", push
the red stop button (B). See figure 18.
LOCKING SWITCH JN
THE "OFF" POSiTiON
When the Dust CoHHector i s not in use, the start button
can be Hocked so that it cannot be started. Using a
padHock (incHuded) through the holies in the side of the
start button.
CiRCUiT BREAKER
Your dust coHHectormotor is suppHied with a resettabHe
circuit breaker. Htis Hocated on top of the start/stop
switch box on the side of the motor. Hfthe motor shuts
off or faiHsto start due to an overHoad condition, turn the
dust coHHector"OFF," Hetthe motor cooHfor three to five
minutes, and push the reset button on the circuit
breaker to reset the breaker. The motor can then be
turned on again in the usuaH manner.
15